SWAN MONOPAL is a high quality elastomer, brushable, water-soluble one-component sealing material, pure acrylic base, with excellent weather resistance. Protects old and new surfaces with a single water vapor permeable elastic membrane of high resistance to moisture, high temperatures and UV rays.ADVANTAGESSingle elastic, waterproof, water vapor permeable membrane without joints and jointsHigh elasticity - at least 300%, following the contraction and expansion of the substrateHigh reflectivity in solar radiation, giving better thermal insulation results.Perfect adhesion to most building surfacesExcellent resistance to moisture and waterMaintains its mechanical properties at temperatures from -15oC - + 70oCExcellent resistance to time and ultraviolet raysSurface walkabilityUser and environment friendly - water solubleEasy application (one component, ready to use)APPLICATIONSRoof and roof waterproofingWaterproofing of gutters, gables, tiles, atriums, Hellenes, etc.Sealing of asphalt surfaces and hard polyurethane foamIt is suitable for cementitious surfaces, asphalt materials, wood, stone, bricks, PVC, polyurethane foam, plaster, metal surfaces, etc.SURFACE PREPARATIONCareful surface preparation is important to have excellent results and long life.Application surfaces must be free of dust, grease, loose residue and moisture that may affect adhesion.Remove all loose parts. The new concrete needs to mature for at least 28 days. The moisture content should not exceed 6%. Old coatings, grease, plant organisms and dust should be removed with the help of an abrasive machine (sander). Surface irregularities must be smoothed. Loose parts or dust from grinding must be removed.REPAIR OF CRACKSCareful repair of cracks is extremely important to achieve long-term sealing.Carefully clean cracks and joints from dust, grease, loose residue.Cracks or openings larger than 2-3mm should be primed with ISOCRYL PRIMER DUR solvent primer or ISOCRYL PRIMER DUR AQUA water primer and sealed with FLEX acrylic putty.Large cracks and expansion joints must be primed with PRIMER PU 900 polyurethane primer and sealed with BONDFLEX polyurethane mastic.Small cracks up to 2-3 mm and the capillaries are recommended to be primed with ISOCRYL PRIMER DUR solvent primer or ISOCRYL PRIMER DUR AQUA water primer. Apply a layer of SWAN MONOPAL and while it is still fresh, apply polyester fabric (approximately 30gr / m2) or fiberglass tape (approximately 60gr / m2) up to 4 - 10cm wide and then another layer of SWAN MONOPAL.PRIMINGPrimer absorbent substrates such as concrete, cement mortar and wood with ISOCRYL DUR AQUA water primer or ISOCRYL DUR solvent primer. Allow the surface to dry for at least 2-4 hours.On non-porous, glossy, or difficult surfaces (metals, ceramic tiles, plastics, etc.) the application of ADHESIL PRIMER is recommended.APPLICATIONApply SWAN MONOPAL with a brush, roller or spray gun, diluted 10% - 20% with clean water. Allow the surface to dry for 12-14 hoursApply a second coat crosswise on the first coat. without dilution or with a minimum dilution of up to 5%For greater protection and insulation or where required, apply a third coat.The surfaces can be pressed after 24 - 48 hours. In the beginning the surface has a stickiness which disappears over time.SWAN MONOPAL should not be applied at very low temperatures (<8oC), at very high temperatures (> 35oC), or when rain or frost is forecast. In case the surface receives direct sunlight, you must ensure that the surface temperature does not exceed the permissible limits. You can wet the surface until the temperature reaches the permissible limits, without stagnant water.